The GL is designed to measure a compression force in a confined space, as a permanent or temporary installation:<\/p>\n
Test benches and tooling Assembly, crimping and press-fit presses Compression tests on components and packaging Load monitoring on machines GL<\/strong>: flat compression sensor with three tapped mounting holes, IP64 protection, temperature compensated from -15 to 70 \u00b0C. Total error \u00b10.8% FS. The right choice for standard integration in the workshop or the laboratory.<\/p>\n FJ<\/a><\/strong>: miniature compression cell with 0.25% FS linearity and hysteresis and an operating range from -54 to +121 \u00b0C. Preferred for higher accuracy or extreme temperatures.<\/p>\n SEJ<\/a><\/strong>: S-type cell for tension and compression, with the best accuracy of the range. Recommended for metrology benches.<\/p>\n
<\/span><\/strong>Measurement of the force under a punch, a cylinder or a plate, without changing the kinematics of the bench thanks to its very low height.<\/p>\n
<\/span><\/strong>Check of the force applied at each cycle to make sure it stays within the defined tolerance.<\/p>\n
<\/span><\/strong>Measurement of the compression force on parts, closures or packaging, in the laboratory or at the line.<\/p>\n
<\/span><\/strong>Mounted with its three tapped holes, the sensor stays in place and follows the force during production.<\/p>\nGL, FJ or SEJ: which sensor should you choose?<\/h2>\n
GL key points<\/h3>\n
\n
Dimensions by capacity<\/h3>\n