The mechanical force gauges AS, AS-M, AS-T are designed for measuring static forces under overhead cranes, tower cranes or any lifting and handling device.
Provided with a large-sized or smaller needle dial (version M) for use in confined spaces, the AS breaks down into two ranges of 6 models covering forces of 500 to 6000 daN.
However, version T of the AS (AS-T) provides the possibility of recording values of up to 200 kN.

Compact and accurate, the CT dynamometric rings enable values to be read off directly thanks to their dial.
Very useful for recording values quickly and accurately, the CT provides both a maximum tensile and compressive force capacity of 500 daN.

Compact and robust, with a stop protecting them from overloads, the CX’s and TX’s are mechanical force gauges that enable tensile or compressive forces to be measured.
Without any delicate mechanism, they are insensitive to variations in temperature and to bad watcher.
The measurement is carried out on the elastic deformation of a spring in a steel case and is indicated by an index which enables instantaneous readings to be taken from a graduated scale.

The FB enables tensile/compressive force measurements to be carried out.
Simple to use and fully mechanical, this force gauges can either be used handheld or fixed on a test stand.
Economical, it is supplied in a case with accessories and fixings.

The digital EPX force gauges is cut into an aluminium block which provides it with protection against impacts.
Steel rings protect the bores from excessive wear of the shackles.
The EPX is fitted with an LCD display allowing direct, easy reading even at long distances.
Very simple to use, it is battery operated and provides multi-unit display.

Remotely controlled, the EHX force gauges provides remarkable accuracy. Divided into 6 models with different capacities, it can be controlled both by means of a keyboard on the device and by infrared remote control. With a range exceeding 80 hours, the battery may be recharged every 10 hours.
Very robust, the EHX lifting force gauges enables the results to be read off remotely thanks to its large red LED screen.

Extremely accurate, the EGX is a remote controlled electronic force gauges.
Extremely robust because of its aluminium case, it is divided into 4 models with different capacities ranging from 1 to 12 tonnes.
Thanks to its remote control and LCD screen, the EGX enables the operator to observe a safe distance of up to 20 m.

The EKX is a force gauges designed for wireless use and is shipped on a crane or hoist.
It consists of a transmitter that comprises a shackle, a sensor and a drum hook, and with a receiver which indicates the result of the measurement remotely and wirelessly.

The BFG digital electronic force gauges is the universal industrial model. Provided with robust aluminium case, it measures both tensile and compressive forces. Very simple to use, it displays the results in different units. It can be used both handheld and mounted on a test stand. It is presented in a case with a charger, accessories and the ACRN calibration certificate.

The AFG digital electronic force gauges is the most efficient in the MECMESIN range, providing the control for electrical stands and the storage of 100 measured values for tensile/compressive force. It can be interfaced with a processor thanks to its programmable I/O’s. It is presented in a case with a charger, accessories and ACRN calibration certificate.

The manual MDD Test Stand is perfectly adapted for the AFG and BFG force gauges. This rigid, light support enables a tensile and compressive force force gauges to be moved. A screw/nut system locks the measuring device in the desired position.
The LCPS is driven by a lever which makes it to push or pull on the force gauges.

The motorised MULTITEST stands represent real test benches for tensile/compressive force. Simple to use, they provide remarkable result accuracy and adaptability. Independent or connected to an AFG force gauges, manual or motorised, with direct reading or reading managed by a microcomputer, the MULTITEST stands enable measurements to be carried out for values ranging from 1 to 25 kN.